From e3835b99333eb3ac7222f6fc0af5cae46074ac49 Mon Sep 17 00:00:00 2001 From: Dmitry Kravkov Date: Sun, 6 Mar 2011 10:50:44 +0000 Subject: bnx2x: (NPAR) prevent HW access in D3 state Changing speed setting in NPAR requires HW access, this patch delays the access to D0 state when performed in D3. Signed-off-by: Dmitry Kravkov Signed-off-by: Eilon Greenstein Signed-off-by: David S. Miller --- drivers/net/bnx2x/bnx2x_ethtool.c | 18 ++++++++---------- 1 file changed, 8 insertions(+), 10 deletions(-) (limited to 'drivers/net/bnx2x/bnx2x_ethtool.c') diff --git a/drivers/net/bnx2x/bnx2x_ethtool.c b/drivers/net/bnx2x/bnx2x_ethtool.c index ef2919987a10..7e92f9d0dcfd 100644 --- a/drivers/net/bnx2x/bnx2x_ethtool.c +++ b/drivers/net/bnx2x/bnx2x_ethtool.c @@ -238,7 +238,7 @@ static int bnx2x_set_settings(struct net_device *dev, struct ethtool_cmd *cmd) speed |= (cmd->speed_hi << 16); if (IS_MF_SI(bp)) { - u32 param = 0, part; + u32 part; u32 line_speed = bp->link_vars.line_speed; /* use 10G if no link detected */ @@ -251,24 +251,22 @@ static int bnx2x_set_settings(struct net_device *dev, struct ethtool_cmd *cmd) REQ_BC_VER_4_SET_MF_BW); return -EINVAL; } + part = (speed * 100) / line_speed; + if (line_speed < speed || !part) { BNX2X_DEV_INFO("Speed setting should be in a range " "from 1%% to 100%% " "of actual line speed\n"); return -EINVAL; } - /* load old values */ - param = bp->mf_config[BP_VN(bp)]; - /* leave only MIN value */ - param &= FUNC_MF_CFG_MIN_BW_MASK; - - /* set new MAX value */ - param |= (part << FUNC_MF_CFG_MAX_BW_SHIFT) - & FUNC_MF_CFG_MAX_BW_MASK; + if (bp->state != BNX2X_STATE_OPEN) + /* store value for following "load" */ + bp->pending_max = part; + else + bnx2x_update_max_mf_config(bp, part); - bnx2x_fw_command(bp, DRV_MSG_CODE_SET_MF_BW, param); return 0; } -- cgit v1.2.3