diff options
Diffstat (limited to 'drivers/usb/dwc3/gadget.c')
| -rw-r--r-- | drivers/usb/dwc3/gadget.c | 56 |
1 files changed, 38 insertions, 18 deletions
diff --git a/drivers/usb/dwc3/gadget.c b/drivers/usb/dwc3/gadget.c index c34170bf2f6f..acab60ba84a7 100644 --- a/drivers/usb/dwc3/gadget.c +++ b/drivers/usb/dwc3/gadget.c @@ -285,27 +285,36 @@ int dwc3_send_gadget_ep_cmd(struct dwc3_ep *dep, unsigned cmd, * is not enough. */ u32 timeout = 20000; + u32 saved_config = 0; u32 reg; int cmd_status = 0; - int susphy = false; int ret = -EINVAL; /* - * Synopsys Databook 2.60a states, on section 6.3.2.5.[1-8], that if - * we're issuing an endpoint command, we must check if - * GUSB2PHYCFG.SUSPHY bit is set. If it is, then we need to clear it. + * When operating in USB 2.0 speeds (HS/FS), if GUSB2PHYCFG.ENBLSLPM or + * GUSB2PHYCFG.SUSPHY is set, it must be cleared before issuing an + * endpoint command. * - * We will also set SUSPHY bit to what it was before returning as stated - * by the same section on Synopsys databook. + * Save and clear both GUSB2PHYCFG.ENBLSLPM and GUSB2PHYCFG.SUSPHY + * settings. Restore them after the command is completed. + * + * DWC_usb3 3.30a and DWC_usb31 1.90a programming guide section 3.2.2 */ if (dwc->gadget.speed <= USB_SPEED_HIGH) { reg = dwc3_readl(dwc->regs, DWC3_GUSB2PHYCFG(0)); if (unlikely(reg & DWC3_GUSB2PHYCFG_SUSPHY)) { - susphy = true; + saved_config |= DWC3_GUSB2PHYCFG_SUSPHY; reg &= ~DWC3_GUSB2PHYCFG_SUSPHY; - dwc3_writel(dwc->regs, DWC3_GUSB2PHYCFG(0), reg); } + + if (reg & DWC3_GUSB2PHYCFG_ENBLSLPM) { + saved_config |= DWC3_GUSB2PHYCFG_ENBLSLPM; + reg &= ~DWC3_GUSB2PHYCFG_ENBLSLPM; + } + + if (saved_config) + dwc3_writel(dwc->regs, DWC3_GUSB2PHYCFG(0), reg); } if (DWC3_DEPCMD_CMD(cmd) == DWC3_DEPCMD_STARTTRANSFER) { @@ -403,9 +412,9 @@ int dwc3_send_gadget_ep_cmd(struct dwc3_ep *dep, unsigned cmd, } } - if (unlikely(susphy)) { + if (saved_config) { reg = dwc3_readl(dwc->regs, DWC3_GUSB2PHYCFG(0)); - reg |= DWC3_GUSB2PHYCFG_SUSPHY; + reg |= saved_config; dwc3_writel(dwc->regs, DWC3_GUSB2PHYCFG(0), reg); } @@ -898,8 +907,6 @@ static void __dwc3_prepare_one_trb(struct dwc3_ep *dep, struct dwc3_trb *trb, struct usb_gadget *gadget = &dwc->gadget; enum usb_device_speed speed = gadget->speed; - dwc3_ep_inc_enq(dep); - trb->size = DWC3_TRB_SIZE_LENGTH(length); trb->bpl = lower_32_bits(dma); trb->bph = upper_32_bits(dma); @@ -969,16 +976,20 @@ static void __dwc3_prepare_one_trb(struct dwc3_ep *dep, struct dwc3_trb *trb, usb_endpoint_type(dep->endpoint.desc)); } - /* always enable Continue on Short Packet */ + /* + * Enable Continue on Short Packet + * when endpoint is not a stream capable + */ if (usb_endpoint_dir_out(dep->endpoint.desc)) { - trb->ctrl |= DWC3_TRB_CTRL_CSP; + if (!dep->stream_capable) + trb->ctrl |= DWC3_TRB_CTRL_CSP; if (short_not_ok) trb->ctrl |= DWC3_TRB_CTRL_ISP_IMI; } if ((!no_interrupt && !chain) || - (dwc3_calc_trbs_left(dep) == 0)) + (dwc3_calc_trbs_left(dep) == 1)) trb->ctrl |= DWC3_TRB_CTRL_IOC; if (chain) @@ -989,6 +1000,8 @@ static void __dwc3_prepare_one_trb(struct dwc3_ep *dep, struct dwc3_trb *trb, trb->ctrl |= DWC3_TRB_CTRL_HWO; + dwc3_ep_inc_enq(dep); + trace_dwc3_prepare_trb(dep, trb); } @@ -1118,7 +1131,7 @@ static void dwc3_prepare_one_trb_linear(struct dwc3_ep *dep, unsigned int maxp = usb_endpoint_maxp(dep->endpoint.desc); unsigned int rem = length % maxp; - if (rem && usb_endpoint_dir_out(dep->endpoint.desc)) { + if ((!length || rem) && usb_endpoint_dir_out(dep->endpoint.desc)) { struct dwc3 *dwc = dep->dwc; struct dwc3_trb *trb; @@ -1914,6 +1927,7 @@ static int __dwc3_gadget_start(struct dwc3 *dwc) /* begin to receive SETUP packets */ dwc->ep0state = EP0_SETUP_PHASE; + dwc->link_state = DWC3_LINK_STATE_SS_DIS; dwc3_ep0_out_start(dwc); dwc3_gadget_enable_irq(dwc); @@ -2037,7 +2051,8 @@ static void dwc3_gadget_set_speed(struct usb_gadget *g, * STAR#9000525659: Clock Domain Crossing on DCTL in * USB 2.0 Mode */ - if (dwc->revision < DWC3_REVISION_220A) { + if (dwc->revision < DWC3_REVISION_220A && + !dwc->dis_metastability_quirk) { reg |= DWC3_DCFG_SUPERSPEED; } else { switch (speed) { @@ -3277,7 +3292,8 @@ int dwc3_gadget_init(struct dwc3 *dwc) * is less than super speed because we don't have means, yet, to tell * composite.c that we are USB 2.0 + LPM ECN. */ - if (dwc->revision < DWC3_REVISION_220A) + if (dwc->revision < DWC3_REVISION_220A && + !dwc->dis_metastability_quirk) dev_info(dwc->dev, "changing max_speed on rev %08x\n", dwc->revision); @@ -3298,6 +3314,8 @@ int dwc3_gadget_init(struct dwc3 *dwc) goto err4; } + dwc3_gadget_set_speed(&dwc->gadget, dwc->maximum_speed); + return 0; err4: @@ -3340,6 +3358,8 @@ int dwc3_gadget_suspend(struct dwc3 *dwc) dwc3_disconnect_gadget(dwc); __dwc3_gadget_stop(dwc); + synchronize_irq(dwc->irq_gadget); + return 0; } |