diff options
Diffstat (limited to 'drivers/mmc/host/mmc_spi.c')
-rw-r--r-- | drivers/mmc/host/mmc_spi.c | 15 |
1 files changed, 12 insertions, 3 deletions
diff --git a/drivers/mmc/host/mmc_spi.c b/drivers/mmc/host/mmc_spi.c index 67f6bd24a9d0..24795454d106 100644 --- a/drivers/mmc/host/mmc_spi.c +++ b/drivers/mmc/host/mmc_spi.c @@ -819,6 +819,10 @@ mmc_spi_readblock(struct mmc_spi_host *host, struct spi_transfer *t, } status = spi_sync_locked(spi, &host->m); + if (status < 0) { + dev_dbg(&spi->dev, "read error %d\n", status); + return status; + } if (host->dma_dev) { dma_sync_single_for_cpu(host->dma_dev, @@ -1150,17 +1154,22 @@ static void mmc_spi_initsequence(struct mmc_spi_host *host) * SPI protocol. Another is that when chipselect is released while * the card returns BUSY status, the clock must issue several cycles * with chipselect high before the card will stop driving its output. + * + * SPI_CS_HIGH means "asserted" here. In some cases like when using + * GPIOs for chip select, SPI_CS_HIGH is set but this will be logically + * inverted by gpiolib, so if we want to ascertain to drive it high + * we should toggle the default with an XOR as we do here. */ - host->spi->mode |= SPI_CS_HIGH; + host->spi->mode ^= SPI_CS_HIGH; if (spi_setup(host->spi) != 0) { /* Just warn; most cards work without it. */ dev_warn(&host->spi->dev, "can't change chip-select polarity\n"); - host->spi->mode &= ~SPI_CS_HIGH; + host->spi->mode ^= SPI_CS_HIGH; } else { mmc_spi_readbytes(host, 18); - host->spi->mode &= ~SPI_CS_HIGH; + host->spi->mode ^= SPI_CS_HIGH; if (spi_setup(host->spi) != 0) { /* Wot, we can't get the same setup we had before? */ dev_err(&host->spi->dev, |